Bends, branches, contraction, expansion etc. associated with ducting system results in pressure drop of the…
It is a difficult property to measure and is expressed as the volume of pores…
It is a difficult property to measure and is expressed as the volume of pores…
Flow of air is caused by a pressure differential between two points. Flow will originate…
Latest From Blogs
-
-
In most average plant situations, the Process design will require that a specific rate of…
-
The conversion of Head to Pressure or vice versa is calculated using following formula in…
-
Bends, branches, contraction, expansion etc. associated with ducting system results in pressure drop of the…
-
The Bogue equations widely used in cement quality control are mathematically based estimates of the…
-
LSF (Lime Saturation Factor) is the theoretical point in the C-S-A-F system where there is…
-
Clinker liter weight on lower side means low burning, low strength in clinker and expansion…
-
Flow of air is caused by a pressure differential between two points. Flow will originate…
-
Cooling rate as described in different cement books and guidelines for better quality of clinker…
-
The specific heat is the amount of heat per unit mass required to raise the…